Model 7705, 10KV AC Hipot - Automated Dielectric Withstand Analyzer
The 7705 is a 10 KV AC Hipot tester that is designed to provide high AC output voltage for cable, wire, harness and electrical component testing. This easy-to-use bench top tester offers numerous features for safe and efficient testing, including our patented SmartGFI® safety circuit. In addition, the 7705 can also be used in tandem with our Autoware® control software.
-
Storage of 50 setups with 8 steps per setup.
-
RS-232 - A standard form of serial communication through a personal computer.
-
4-wire measurement and milliohm offset
-
Interconnects to the RUNCHECK nad LINECHECK to form a complete test system
Additional key features:
SmartGFI® - The patented SmartGFI is a high speed shut down circuit that provides maximum operator protection. If the circuit detects excessive leakage to ground it shuts down the high voltage in less than 1 millisecond. SmartGFI is automatically activated if the DUT is not grounded. The operator does not need to make the decision whether to activate the SmartGFI.
Digitaly Controlled ARC Detection - The ability of a circuit to detect the short duration current spikes normally in the range of 10 microseconds which have peak amplitudes in the milliamp range. These high frequency spikes normally appear on the peaks of the output wave prior to catastrophic or destructive arc breakdown which result in complete failure of the insulation.
Standard Items included: |
Item |
Description |
Qty |
07705 |
7705 Instrument |
1 |
MANUAL |
Owner's Manual |
1 |
38712 |
Cable Assy HV 12kV |
1 |
38736 |
Cable Assy Return |
1 |
37800 |
Rack Mount Bracket |
2 |
37801 |
Rack Mount Handle |
2 |
Note: Signal Test is only authorized to ship Associated Research products to: California, USA and Nevada, USA. Also, Baja California, Mexico and Sonora, Mexico. |